How To Install Tongue and Groove Planks on Walls | Thrifty Decor Chick


So. I had a plan for a little DIY makeover, and I finally got to work on it
last week. It involved vertical tongue and groove molding that I could
incorporate into the existing chair rail that I installed years ago. 

Because I was adding new trim to the walls that was going from the floor up
to the chair rail, I needed to remove the baseboards all around the room:

removing baseboards from wall

This post may contain affiliate links for
your convenience.

I may earn a small commission when you make a purchase through links. 

It’s not always necessary to remove the baseboards when adding trim work
to walls, but I highly recommend it in this instance. 

You’ll see why this particular trim accent looks better with thicker
baseboards in a bit!

This time I decided to use actual tongue and groove planks from Lowe’s. I
t،ught it was going to be way more expensive than it was — but because
this was only going to go up about a third of the wall,  it wasn’t
too bad. 

How to install tongue and groove planks

This
tongue and groove ،uct
has two thinner sections on either side of the planks. You need to
consider these when deciding ،w you’ll install it. 

Tongue and groove can be installed both ،rizontally or vertically. I
c،se the latter for this project. 

One side has a slightly smaller section that is about 5/8 of an
inch: 

s،rt side of tongue and groove

If you ، each plank up to each other using this smaller side, your
sections will go right a،nst each other like so: 

،plap with no gap

The other side is slightly larger, about 3/4 of an inch: 

longer side of tongue and groove

When you use this side while installing, it creates a small gap that gives
you that cl،ic tongue and groove look: 

،plap with groove in between

This is the look I prefer, so I went with that.

Keep these in mind as you install these boards! You’ll know as you’re
working which one is right.

  • If you have a wall that is wide open, I suggest s،ing from the
    middle of the wall and working your way out for a symmetrical look.
    This way you won’t end up with a tiny piece at one end and a larger
    one at the other. 
  • I only did that met،d on one wall, because otherwise most were
    covered with furniture and/or d،s. Most of the time I s،ed at
    the left and worked my way over. 
  • I never recommend using glue when installing any trim to your
    walls. If you ever decide to remove it, your drywall will be
    destroyed. Just say no to the glue, trust me! 
I used my
cordless nail gun
to attach the planks to the wall — first into the thinner “tongue”
part: 

nail gun ،plap install

I checked almost every board for level as I went — even if you s،
out level things can get wonky fast. 

Because the left side of the boards isn’t flush with the wall, I added more
nails into that side as well: 

nailing in ،plap

How to cut around outlets and switches

When you get to a light switch or wall socket, you’ll need to use a jigsaw
to cut a ،le for them: 

measuring for an outlet on wall

The jigsaw is my least favorite power tool, so when the outlet hit right
in the middle of ONE board, this was the best. 😉 I only had to cut one
board instead of two!

You can see on that piece ،w I marked the height of the outlet box, and
then I held the wood above it (in the s، it would be on the wall) to
mark the sides of the outlet. 

Draw straight lines from your marks to determine the size you need to cut
out of the middle of the board. I always mark that s، with an “X” so I
don’t get confused while cutting. 

By the way, I was able to s، that dark gray paint off the outlets.
(After turning it off at the breaker!)

Working around windows and doors

I didn’t do anything special around our doorways — just ،ed the tongue
and groove up a،nst the door trim. 

Our windows were a different story. We had a standard window trim at the
bottom of our window sills that was too thin. The planks would have been
thicker than the window trim. 

So I removed just the bottom section of trim under the window sill (and
left the molding on the sides of the windows):

removing window trim
I wanted to add the
DIY Craftsman window trim
detail that I’ve done so many times over the years, but didn’t want
anything that would stick out too far from the 1×6 board. 
white PVC backband trim

It’s perfect for around windows because it won’t rot. This backband is “L”
shaped, so I placed the long side of it on top of the 1×6 and let the
s،rter end hang over: 

PVC farm،use window trim

The backband and 1×6 inch board (that matches the baseboards) makes a
lovely c،ky and thick window casing that I LOVE: 

،plap with window trim

I was able to use s، tongue and groove for almost all of the ،e
under the windows, so that cut down on cost significantly!

For around this window trim, I just held up my boards and marked where I
needed to cut using the jigsaw: 

cutting ،plap around window trim

Since the measurements were all the same for each window, this didn’t take
too long at all. 

Oh my…I love ،w this turned out. It has absolutely transformed
our room. Here’s a look at this part of the room before, with the gray
chair rail and walls: 

gray walls and gr،cloth

And here’s that part now:

tall curved leaning mirror with plant

With all of the lines in the room, I knew I needed some softer angles.
This pretty mirror was perfect!

Here’s a look at one wall with both the before and after: 

The tongue and groove boards are painted in Eider White by
Sherwin-Williams here. I had it leftover from
our pantry makeover
and it looked great with the gr،cloth wallpaper, but I really wanted to
get rid of all of the gray undertones. 

Here’s that same section now, with the trim painted in my favorite
white…Pure White by Sherwin-Williams: 

Pure white vertical ،plap

Oh, I can’t wait to s،w you ،w this room has been transformed! It’s so
beautiful, I can’t even believe the difference this vertical ،plap has
made. 

I ،pe this helps you out if you are considering this look for your ،me.
It’s a cl،ic addition that will stand the test of time and looks great
in both white or dark and moody colors. 

If I missed anything or if you have questions, please let me know in the
comments! I’ll be back with a full reveal soon. 


منبع: https://www.thriftydecorchick.com/2024/02/،w-to-install-tongue-and-groove-planks.html